IMR 1400 Flue Gas Analyzer

• The combustion gas analyzer IMR 1400 CO is easy to use, compact and rugged. 

• Two CO-sensors are installed, one for low measurements and one for high CO-measurements.

• This helps to get the best possible accuracy for different applications (e.g. wood fired applications). 

Measured Parameters:

• Oxygen O2

• Carbon monoxide CO in ppm

• Carbon monoxide CO in Vol. %

Calculated Parameters:

• Losses QA

• Combustion Efficiency ETA

• Excess Air LAMBDA

• Carbon dioxide CO2 

• Case: Rugged aluminum with an additional compartment

• Sensors: O2-CO-CO

• Display: Illuminated and simultaneous display of 8 values

• Fuels:7 programmed; 5 programmable

• Units:ppm, mg, mg(O2), mg/kWh

• Interface: RS232

• Memory:200 measurements

• „Battery: Status is shown on the LCD; 6 hrs 

• Printer: Highspeed thermal-printer;

• Width 58mm; Capable of printing 1, 2, or 3 printouts at once with all values including date, time and fuel type

• CO-Switch: Solenoid valve to automatically switch between the low and high CO-sensor. 2nd pump to purge the low COsensor (faster regeneration);

• Soot measurement: Electronic controlled pump

• Zero-point adjustment:3 min

• Service program: Component check and printout capability of all parameters;

• Measures flue-gases of boilers, burners, engines,.

• Developed to meet the customers need

• High-quality combustion gas analyzer using the latest sensor technology

• Easy to use and it measures all important parameters

• Includes all needed features for a complete analysis

Standard Features:

• Illuminated display with simultaneous display of 8 measured variables

• Languages: D, UK, F, USA, E, TR, etc.

• 7 programmed and 5 programmable fuels

• Measurement display is switchable between ppm, mg, mg(O2), and mg/kWh

• Battery status is shown on the measurement display

• Interface RS 232

• Printout of all measured and calculated parameters

• Electronic controlled soot measurement

• Automatic and manual CO overflow shut-off

• Automatic zero calibration within 3 minutes. Recalibration within 30 sec.

• Integrated self-check program for all functions and parameters.

• After 1000 operating hours a 'Service needed' note appears on the display.

• Gas sampling probe, length 10.5' (270mm),NiCrNi, flexible hose 11.5 ft. (3,5m)

• Combustion air probe, length 5' (130mm), line 11.5 ft. (3,5m)

• Condensation trap with integrated filter

• Operating temperature 50°F..104°F (10°C..40°C)

• Storing temperature -4°F..122°F (-20°C..50°C)

• Power supply  230V/50Hz, 110V/60Hz, 12VDC

Document: