SunMaxx Solar Charge Controller 10A 12V/24V with 2 USB Port

The product can automatically manage the working of solar panel and battery in solar system. For protecting the lifespan of your battery, once the voltage of the battery drop below 8V, the solar controller will turn off automatically (LCD will be unavailable at the same time).

The solar charge controller with dual USB ports, USB Output: 5V/2A max. 12V/24V auto; Rated Charge & Discharge Current: 10A; Settable operating modes of loads, fully 4-stage PWM charge management.

Solar Charge controller is only suitable for lead-acid batteries: OPEN, AGM, GEL, not for nickel hydride, lithium, Liions, or other batteries. For protecting the lifespan of your battery, once the voltage of the battery drop below 8V, the solar controller will turn off automatically

Short-circuit protection,open-circuit protection, reverse protection, overload protection, more safety for using, suitable for home, industrial, commercial etc.

Solar controller can clearly indicate the status and data, it can be conveniently switched modes and parameter configuration.

Dual mosfet reverse current protection, low heat production(ALL electronic components generate heat when they are running, it is better to shelter them for better heat dissipation, avoid direct sunlight exposure or damp place)

Wiring STEPS: Screw the adjustment screw counter-clockwise until the plates move down. Insert the wire into the new opening between the plate and the "top" of the Terminal hole, not under it. Screw the adjuster clockwise and the plate will move upwards thereby squishing the wire

in the Terminal hole.

Installation STEPS：Connect the system in the order of 1.Battery > 2. Load > 3.PV Array in accordance with Figure, and disconnect the system in the reverse order 3. 2 .1.